Troubleshooting – Toshiba Programmable Controller PROSEC T3 User Manual
Page 83
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6. Troubleshooting
6.1
Troubleshooting
procedure
If a trouble occurs, determine whether the cause lies on the
mechanical side or on the control system (PLC) side. A problem
may cause a secondary problem, therefore, try to determine the
cause of the trouble by considering the whole system.
If the problem is found in the T3 or in the T3’s I/O operation, check
the following points:
If the user program operation is
abnormal, follow the procedure in
6.4, Checking the program.
If an abnormalit/ is found in an
input module, follow the procedure
in 6.5, Checking input.
If an abnormality is found in an
output module, follow the procedure
in 6.6, Checldng ou^ut.
If the problem appears temporary and is synchronous with the
operation of the system/equipment, the external environment
(noise, voltage fluctuations, etc.) may have caused it. For details,
follow Section 6.7.
User's manual - Hardware
75