Echelon FT 3150 Smart Transceiver - Manual (Page 123)

FT 3120 / FT 3150 Smart Transceiver Data Book 117
NodeBuilder Development Tool
Specify the target hardware clock speed in Clock Speed on the Hardware tab. Specify the address map on the Off-
chip Memory tab for the device. For example, a 32K part will have Non-volatile End set to 7FFF and all other fields
set to 0. Also, select the memory part Type. For memory parts, you must specify the sector size. For EEPROM
memory, you must set the write time. A list of Echelon tested external memory components can be found on the
Echelon website at www.echelon.com.
Once the hardware template has been created, drag the new hardware template to the device. Drag the newly created
icon in the User Templates folder to the Release folder of the device template to complete the procedure.
Note: You can update the user-defined hardware template later by double-clicking the template icon. Your new
changes will affect any projects opened and compiled using this template. A Build All may be required if you change
a hardware template without making any other changes.
Warning: Flash memory must be explicitly secured by the PROM programmer once the image is programmed. See
SDP information provided by the manufacturer of the PROM programmer.
Warning: All FT 3120 Smart Transceivers must be programmed with the generated EEPROM application image file
(.nei extension), or the corresponding flash application image file (.nfi extension), before they are soldered onto a
PCB assembly.