Altera Floating-Point - Manual (Page 62)

Parameter Name Type Required Description
OPTIMIZE
String No Specifies whether to optimize for area or for speed.
Values are
AREA
and
SPEED
. A value of
AREA
optimizes
the design using less total logic utilization or resources.
A value of
SPEED
optimizes the design for better
performance. If this parameter is not specified, the
default value is
SPEED
.
PIPELINE
Integer No Specifies the number of clock cycles needed to produce
the result. For the single-precision format, the latency
options are
33
,
14
or
6
. For the double-precision
format, the latency options are
61
,
24
or
10
.
For the single-extended precision format, the value
ranges from a minimum of
41
to a maximum of
61
.
For the low-latency option, the latency is determined
from the mantissa width. For a mantissa width of
31
to
40
bits, the value is
8
or
18
. For a mantissa width of
41
bits or more, the value is
10
or
24
.
6-8 ALTFP_DIV Parameters
UG-01058
2014.12.19
Altera Corporation ALTFP_DIV IP Core
Send Feedback