Adtec digital Soloist-HD Pro (version 02.07.09) Manual - Manual (Page 29)

DVB-ASI
Mode
Enable or disable the DVB_ASI
receive operation
OFF
Recieve
*.DCMD DVB
DVB-ASI
Latency
Sets the latency delay (in
milliseconds) before the decoder
begins playback from the DVB ASI
source
text field;
default is 100 (ms)
*.DCMD DLT
DVB-ASI
Error
Recovery
Sets the timeout value (in
milliseconds) for recovery of DVB
ASI receive after decoder error
condition is detected
text field;
default is 100 (ms)
*.DCMD DER
Multicast
Mode
turns streaming MPEG to off,
receive, or send; used when unit is
part of a LAN or WAN and is
receiving IP streaming
Off
Receive
*.DCMD MMO
Multicast
Port
port number for receiving multicast
on the defined Multicast IP Add.
0-65535 *.DCMD MRP
Multicast
IPA
sets the multicast receive Group IP
address. IP Multicast receiving is
supported from compatible
streamers.
user-defined
default is 0.0.0.0 *.DCMD MRI
Error
Recovery
Sets the timeout value (in
milliseconds) for recovery of
multicast receive after decoder
error condition is detected.
text field:
default is 10000
(ms)
range is 33-600000
(ms)
*.DCMD MER
Time Out
(ms) sets the timeout value in
millisceonds for return-to-normal
video playback after video
multicast packets are no longer
detected
text field;
default is 300 (ms) *.DCMD MTU
RTP
(Auto-
Detect)
When on, the system adapts to the
stream received, automatically.
When off, if an RTP stream is
received, the video component will
appear corrupted to the decoder.
On
Off
*.DCMD RAD
Multicast
Connector
Sets the physical connector (on the
rear of the unit) to use for
multicast purposes. Recommended
setting is GigE (10/100/1000)
Ethernet
GigE
*.DCMD MCN