Adtec digital Soloist-HD Pro (version 02.07.09) Manual - Manual (Page 65)

LSTxxxDVC Files
List DVC files are text files that contain a list of media files to play in a sequential order.
A sample play list with video, music, and pictures may look like the following.
When the following file is loaded onto the player it can be instantly loaded and played by issuing a *.sysd
RUN LSTAUTO.DVC command or by resetting the box. The RUN command will load a DVC list into memory
and play it immediately.
PARxxxx.DVC Files
Par DVC Files are text files that configure the data inputs of the parallel port. The ‘Parallel Port’ section
contains more hardware information on the parallel port.
A sample PAR file may look like the following:
The first letter of the file must be a B for bitmode (4 inputs) or M for multplex mode for muxmode (15
inputs, 16 data bits) utilized with an Adtec PARMUX board.
Each row afterwards is for each data bit, D0 – D3 where D0 = Pin 5, D1 = Pin 4, D2 = Pin 3, and D3 = Pin
2. Each state is separated by open and closed brackets ‘[‘ ‘]’ that will contain an API command to run. The
states are low, rising, high, and falling respectively as seen in the next section.
The rising edge is the most common state to put commands in. A combination of rising and falling can be
used for latching contact closures. A non-usable text sample of the rows and columns.
PIN / BIT LOW RISING HIGH FALLING
5 / D0 [ ] [ ] [ ] [ ]
4 / D1 [ ] [ ] [ ] [ ]
3 / D2 [ ] [ ] [ ] [ ]
2 / D3 [ ] [ ] [ ] [ ]