Adtec digital Soloist-HD Pro (version 02.07.09) Manual - Manual (Page 68)

A complete list of recommended and supported video resolutions can be found in Chapter 2 under the
Display Target section.
Troubleshooting Guide
Issue Cause
The video displays but appears shaded in
magenta or green. The colorspace of the selected display
target does not match the monitor and/or
connection type used. Either switch your
video display target or switch your
connector.
No video is displayed or the monitor reports
that it has 'no sync' or 'out of range'
Possibility 1: The wrong input is selected on
your monitor.
Possibility 2: A display target has been
chosen that is not supported by your
monitor.
The video is displayed but does not fill the
entire screen, there may be black bars on
the top and bottom or on the sides
Possibility 1: The view mode of the monitor
is set incorrectly (full-screen, stretch, dot-
for-dot, through, etc.)
Possibility 2: The monitor input being used
is expecting a different resolution (aspect
ratio) than the selected display target is
providing