Baby Lock Crescendo (BLCR) Instruction and Reference Guide - Manual (Page 84)

STITCH SETTINGS
S-10
When you select a stitch, your machine automatically selects the appropriate stitch width, stitch length,
“L/R SHIFT”, and upper thread tension. However, if needed, you can change any of the individual
settings.
Setting the Stitch Width
Follow the steps below when you want to change
the zigzag stitch pattern width.
Example:
Press to narrow the zigzag stitch pattern
width.
→ The value in the display gets smaller.
Press to widen the zigzag stitch pattern width.
→ The value in the display gets bigger.
Setting the Stitch Length
Follow the steps below when you want to change
the stitch pattern length.
STITCH SETTINGS
Note
• Settings for some stitches cannot be changed (refer to the “STITCH SETTING CHART” on page S-68).
• If you turn off the machine or select another stitch without saving stitch setting changes (“Saving Your
Stitch Settings” on page S-22), the stitch settings will return to their default settings.
Memo
• For an alternate method of changing the
stitch width using the speed controller, see
page S-39.
Memo
• Press after pressing to return to the
original setting.
Note
• After adjusting the stitch width, slowly
rotate the handwheel toward you
(counterclockwise) and check that the
needle does not touch the presser foot. If
the needle hits the presser foot, the needle
may bend or break.