Adding units, Adding units -19, Add -19 – Comtech EF Data Vipersat Load Utility v3.5.x User Manual
Page 43: Figure 3-12
Advertising
Chapter 3 - Using VLoad — Vipersat Mode
3-19
Unit Listing and Selection
Figure 3-12 Unit Information window
Adding Units
A unit is added to the list by either:
•
Clicking the Add button, or
•
Clicking the Add All button
Add
Clicking the Add button allows adding a single Vipersat modem using the
dialog shown in Figure 3-13.
Figure 3-13 Add New IP Address dialog
Note: The SLM-5650A has three IP addresses: the Base Modem address, the
TRANSEC (transmission security) address, and the Router/NP (network
processor) option card address. Only use the IP address of the NP card
with VLoad.
NOTE
Advertising