Daktronics Pro Series Operations and Maintenance Manual - Manual (Page 63)

Figure 8.6: Motor 0 is omitted.
Figure 8.7: Change position arrows
Figure 8.8: After position is changed
Keypad
UPR (upper limit)
Joystick
Up
Down
LWR (lower limit)
Figure 8.9: Target controls
Omit Motor
In some presets, not every motor is used. To
remove a motor from the list, select it and touch
OMIT MOTOR.
The motor name will deactivate to show that it
will not move in the preset (Figure 8.6).
Move in List
To change the sequence in which the motors move,
select the motor and touch the MOVE IN LIST button.
Choose a new list position for the motor by touching
one of the grey arrows that appear (Figure 8.7).
MOVE IN LIST changes to read ACCEPT.
Touch ACCEPT to confirm the new list position. The
order list displays the updated order (Figure 8.8).
All
To add all omitted motors back into the order list,
touch ALL. When omitted motors are added, check
to make sure the target values are correct.
Target controls
Select a motor from the list by touching its name.
Now the top of the Target controls will display
the name of the selected motor (Figure 8.9).
56