Daktronics Pro Series Operations and Maintenance Manual - Manual (Page 80)

MOVE TO POSITION
To move a batten to a specific
height, touch MOVE TO POSITION (Figure 9.25).
The controller will display a new panel with a
keypad (Figure 9.26). Enter the desired target using
the keypad. Set the speed for the move by using the
speed button and touch MOVE. The motor will move
to the target and stop.
While the motor is moving, the Move To Position
button will be changed to read Stop. The Stop
button will slow and stop the motor prior to
reaching its target.
AUTO UP / DOWN
To move the motor to its upper or lower limits,
touch AUTO UP / DOWN (Figure 9.27).
The controller will display a new panel with
between two and five buttons (Figure 9.28):
• Upper limit
• Alternate targets (if any)
• Lower limit
To move to a limit, set the speed using the speed
button, then touch and hold either of the limit
buttons for three seconds.
When the motor begins moving, the CANCEL
button will change to STOP. Touch STOP to halt
the motor movement.
Note: During any hoist movements, in an
emergency, press the Emergency Stop button.
Figure 9.25: Move To Position button
Figure 9.27: Auto Up/Down button
Figure 9.28: Auto Up/Down panel
Upper limit
Alternate target
Lower limit
Alternate target
Alternate target
Figure 9.26: Move To Position panel
73 SETUP