Niveo Professional NGS16TP - Manual (Page 18)

14
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
6.2 Settings with Console Connection
6.2.1 Basic of the Console Interface
<< Enter Console Interface >>
Please follow the steps to complete the console hardware connection first.
1. Connect from console port of the switch to COM port of PC with the console cable.
2. Start the terminal program of Windows. Create a new connection and select COM
port of PC used for the console. Set the configuration of the terminal as
[9600,8,N,1]. (You can find the terminal program in [Start] -> [Programs] ->
[Accessory Programs] -> [Communication] -> [Terminal]. If you cannot find it, please
install it from your Windows Installation Disk. Please refer to your Windows user
manual for the installation.)
3. Power on the switch.
If everything is correct, the booting screen will appear in the terminal program when the
switch is powered on. It will stop at the following screen after some initializing
messages.
-------------------------------------------------------------------------------------------------------
Booting Program Version 1.04.04-SI/PI, built at 12:04:53, Sep 17 2008
RAM: 0x00000000-0x00800000, 0x0000cc78-0x007f3000 available
FLASH: 0x05800000 - 0x05a00000, 32 blocks of 0x00010000 bytes each.
==> enter ^C to abort booting within 3 seconds ......
Start to run system initialization task...
[System Configuration]
Company Name :
Model Name : Switch
MAC Address : 00:12:34:64:99:6F
Firmware version : 1.05.14
Username:
-------------------------------------------------------------------------------------------------------
<< User Modes >>
There are two user modes for the switch - one is administrator mode (privileged mode),
another is guest mode (normal mode).
[ administrator mode ]
The default user name and password is "admin" / ”admin”.
After login the switch, a prompt will be shown. Because this switch supports command-
line for console interface, you can press “?” to check the command list first.