Niveo Professional NGS16TP - Manual (Page 69)

65
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
priority queues mapping. There are four priority queues on each port of the switch.
# show map ?
dscp IP DSCP priority map
port IP port priority
priority 802.1p priorities map
show map dscp command is used to show IP DSCP QoS function enable/disable status,
and DSCP values(0~63) to priority queue mapping on each port.
show map dscp ethernet 1/x command is used to show DSCP values(0~63) to priority
queues mapping on Port x. (“x” is the port number.)
show map port command is used to show connection port to priority queues mapping.
This is called port-based priority.
show map priority command is used to show 802.1P priority values(0~7) to priority
queues mapping on each port.
show map priority ethernet 1/x command is used to show 802.1P priority values(0~7)
to priority queues mapping on Port x. (“x” is the port number.)
17. show mvr command
This command is used to show MVR configuration.
show mvr command is used to show MVR VLAN setting one after another.
show mvr x command is used to show a MVR VLAN setting. “x” is the VLAN ID.
For example,
# show mvr 11
Active: Yes
Name:
MVLAN: 11
802.1p Priority: 0
Mode: Dynamic
Source Port: Eth1/ 10
Receiver Port: Eth1/ 5 Eth1/ 6 Eth1/ 7
MVR Group Configuration:
Name Start Address End Address
--------------- --------------- ---------------
abc 224.0.0.1 224.0.0.2
abcd 224.0.0.3 224.0.0.4
18. show port command
This command is used to show port mirror function setting.
show port monitor command is used to show port mirror function setting.
For example,