Niveo Professional NGS16TP User Manual
Page 65
61
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
For showing filter IP address, “show interface switchport” command will show port
settings one after another. And “show interface switchport ethernet 1/x” command
will show Port x settings.
10. show lacp command
This command is used to show current LACP configuration of the switch.
# show lacp ?
internal Shows config settings/operational state for local side
portstatus Shows LACP Port Status
sysid Shows channel groups system priority/MAC address
show lacp internal command is used to show system priority and protocol
enable/disable status of ports.
# show lacp internal
[Lacp Port Configuration]
System Priority: 65535
Port Protocol Enabled
------- ------------------
Eth 1/1 Disable
Eth 1/2 Disable
Eth 1/3 Disable
Eth 1/4 Disable
Eth 1/5 Disable
Eth 1/6 Disable
Eth 1/7 Disable
Eth 1/8 Disable
Eth 1/9 Disable
Eth 1/10 Disable
show lacp portstatus command is used to show LACP working status of ports.
# show lacp portstatus
[ LACP Port Status ]
Port Protocol Active Partner Port Number Operational Port Key
1 no
2 no
3 no
4 no
5 no
6 no
7 no
8 no
9 no
10 no
show lacp sysid command is used to show system ID of the switch for LACP protocol.
# show lacp sysid
65535