Niveo Professional NGS16TP - Manual (Page 36)

32
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
assign IP multicast groups (video channels) to the MVR VLAN. And you can assign more
than one IP multicast groups (video channels) to one MVR VLAN. “x” is the MVR VLAN
ID. “yyy” is the name of the IP multicast group. “m.m.m.m” is the start IP multicast
address. “n.n.n.n” is the end IP multicast address. For example, “mvr 10 group abc
start-address 224.0.0.1 end-address 224.0.0.2”. “no mvr x group yyy” command is
used to delete the IP multicast group named “yyy” from MVR VLAN “x”.
mvr x mode compatible / mvr x mode dynamic command is used to set the operation
mode of the MVR VLAN. There are two operation modes for this MVR function. One is
Dynamic mode. Another is Compatible mode. In Dynamic mode, the switch will send
IGMP reports to every MVR source port in the MVR VLAN. In Compatible mode, the
switch will not send IGMP reports. “x” is the MVR VLAN ID.
mvr x name yyy command is used to assign a name to the MVR VLAN. “x” is the MVR
VLAN ID. “yyy” is the name string.
After MVR VLAN is created, source port of IP multicast traffic and receiver ports of
subscribers will be assigned next. Assigning source port and receiver port to MVR VLAN
is done in “(config-if)#” mode (go with “interface ethernet 1/x” command. “x” is the
port number.) Please refer to “mvr” command in Section 6.2.4.1 for the details.
22 no command
This command is used to disable a function or restore a setting to factory default of
the switch.
(config)# no ?
aaa
AAA Service
automode Set Auto Negotiation or Auto Detect mode
dhcp-relay Set Auto Negotiation or Auto Detect mode
dot1x
Configures 802.1x port-based access control
hostname Sets system's network name
ip
Global IP configuration sub commands
ip-filter Enable IP address filtering function
lacp Configures LACP status
logging Modifies message logging facilities
mac-address-table Configuration of the address table
management Specifies management IP filter
mirror Configuration of mirror
mvr Multicast VLAN Registration
qos Configuration of QoS
queue Assigns priority queues
radius-server Configures login to RADIUS server
rate-limit Configures rate-limits
snmp-server
Modifies SNMP server parameters
sntp Simple Network Time Protocol configuration
spanning-tree Configures spanning tree parameters
storm-control Configures storm control
trunk
Configures trunk function
For example,