Niveo Professional NGS16TP - Manual (Page 19)

15
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
With “?” command, you can find the command list as follow.
---------------------------------------------------------------------------------------------
# ?
exit Exit from current mode
help Show available commands
history Show a list of previously run commands
logout Disconnect
ping Sends ICMP echo packets to other network nodes
quit Quit commands
reload Halts and performs a warm restart
show Shows information
calendar Data and time information
configure Enter configuration mode
copy Copies from one file to another
#
---------------------------------------------------------------------------------------------
These are the basic system commands for the switch.
For system configuring, “configure” command can enter the configure mode. And the
prompt will become ...
----------------------------------------------------------------
# configure
xxxx(config)#
----------------------------------------------------------------
In the configure mode, the general configuration of switch can be done. And “exit”
command can leave this mode.
If settings for port, “interface” command is used. And the prompt will become ...
----------------------------------------------------------------
xxxx(config)# interface ethernet 1/5
xxxx(config-if)#
----------------------------------------------------------------
“ethernet 1/5” means Ethernet interface 1, port 5. And “exit” command can leave this
mode.
“interface” command has another sub-command “vlan”. IP address of the switch can be
configured in this mode.
----------------------------------------------------------------
xxxx(config)# interface vlan 10
xxxx(config-if)#
----------------------------------------------------------------
[ guest mode ]
If “guest” / “guest” is used for username / password, the console inerface will enter