Niveo Professional NGS16TP - Manual (Page 24)

20
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
radius-server RADIUS server information
running-config Information on the running configuration
rate-limit
Configures rate-limits
snmp Simple Network Management Protocol statistis
sntp Simple Network Time Protocol configuration
spanning-tree Spanning-tree configuration
system
System information
trunk Trunk information
version System hardware and software versions
vlan Virtual LAN settings
With sub-commands, different configuration settings will be displayed.
More help information for them will be prompted with “show xxxx ?” (xxxx is the sub-
command). For example, entering “show ip ?” will get the prompt message...
# show ip ?
igmp
IGMP snooping
interface Interface information
redirects Default gateway configured for this device
And entering “show ip igmp ?” will get next help message...
# show ip igmp ?
snooping IGMP snooping configuration
And entering “show ip igmp snooping” will get the IGMP settings...
# show ip igmp snooping
IGMP Status:
Disable
IGMP Querying: Disable
IGMP Querying: Disable
IGMP Query Interval: 125 seconds
IGMP Report Delay: 15 seconds
IGMP Query Timeout: 255 seconds
If the display is more than one console page, “Esc” can be used to break the display.
For the details, please refer to section 6.2.6 Show commands.
9. calendar command
This command is used to set the system time. It is entered in <hour minute second
month day year> order.
For example,
# calendar set 10 30 0 october 15 2008
# show calendar
Current Time : 2008/10/15-10:30:18
It is 18 seconds passby after the setting command.
10. configure command