Niveo Professional NGS16TP - Manual (Page 57)

53
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
This command is used to logout from console interface.
5 quit command
This command is used to quit from console interface. It has the same function as
logout.
6 end command
This command is used to exit from VLAN Configuring mode.
(config-vlan)# end
(config)#
7 1q-vlan command
This command is used to configure 802.1Q VLAN characteristics.
(config-vlan)# 1q-vlan ?
gvrp
Enables GVRP globally for the switch
ingress-filtering Configures frame filtering base on VLAN membership
<cr>
1q-vlan command can enable 802.1Q VLAN function. And no 1q-vlan command can
disable it.
1q-vlan gvrp command is used to enable GVRP function of 802.1Q VLAN. This
command works only if 802.1Q VLAN is enabled. And GVRP will be disable
automatically when 802.1Q VLAN is set to disable. no 1q-vlan gvrp command can
disable it.
1q-vlan ingress-filtering command is used to enable doing VLAN membership filtering
at ingress port instead of egress port. no 1q-vlan ingress-filtering command can
disable it.
8 no command
This command is used to disable a function or restore a setting to factory default of
the switch.
(config-vlan)# no ?
1q-vlan
Configures 802.1Q VLAN
port-vlan Configures Port-Based VLAN
private-vlan Private VLAN
vlan
Switch Virtual LAN interface
For example,
“1q-vlan” command can enable 802.1Q VLAN function and “no 1q-vlan” command can
disable it. “no vlan 100” command will remove VLAN 100.