Niveo Professional NGS16TP - Manual (Page 35)

31
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
management x mode modify/view command is used to set the access right for some
user groups (“x” is the index of the user group). If “management x mode modify”
command, users in this groups have “modify” right for management. If “management
x mode view” command, users in this groups have “view” right only.
management x protocol http|snmp|telnet command is used to enable the remote
management protocol for some user groups (“x” is the index of the user group). More
than one protocols can be enabled at the same time - e.g. “management 2 protocol
http snmp telnet”. And no management x protocol command is used to disable all
remote management protocols for the user group.
20 mirror command
This command is used to enable mirror function of the switch. And no mirror
command can be used to disable mirror function of the switch.
21 mvr command
This command is used to configure MVR (Multicast VLAN Registration) function. VLAN
function will isolate traffic between VLAN groups. But it will also isolate IP multicast
traffic for subscribers in different VLANs. The MVR function allows one multicast VLAN
to be shared by subscribers in different VLANs. That can reduce the multicast traffic
for VLANs.
** Before configuring MVR function, complete the VLAN setting first
** Using MVR function, you have to enable IGMP snooping function first.
This switch supports three MVR VLANs. They are referred with their VLAN ID. For any
MVR setting, you have to assign the VLAN ID in the command.
Entering “mvr x ?”, the sub-commands will be shown. “x” is a VLAN ID with number in
2~4094. For example, “mvr 10”.
(config)# mvr 10 ?
8021p-priority Configure 802.1p priority tagging
active
Active a MVR VLAN
group Create a multicast group for MVR VLAN
mode Set MVR VLAN operation mode
name Set MVR VLAN name
<cr> Create a MVR VLAN
mvr x command is used to create a MVR VLAN with VLAN ID “x”. “no mvr x” command
is used to delete a MVR VLAN.
mvr x 8021p-priority y command is used to set the 802.1P priority (0~7) for MVR
operation. The IGMP control packets for this VLAN will be assigned this priority when
tag is added. “x” is the MVR VLAN ID. “y” is the 802.1P priority value.
mvr x active command is used to set the MVR VLAN to “active” state. “x” is the MVR
VLAN ID. “no mvr x active” command is used to set the MVR VLAN to “inactive” state.
mvr x group yyy start-address m.m.m.m end-address n.n.n.n command is used to
create a IP multicast group for the MVR VLAN. After MVR VLAN is created, you can