Niveo Professional NGS16TP - Manual (Page 48)

44
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
port-vlan Configures Port-Based VLAN
power-saving Decrease energy consumption
qos
Configuration of QoS
rate-limit Configures rate-limits
shutdown Shuts down the selected interface
spanning-tree Specifies spanning tree configuration
speed
Configures speed operation
switchport Configures switching mode characteristics
For example,
“lacp” command can enable the LACP function on the interface port(s) and “no lacp”
command can disable it.
“maximum-packet-length 9600” will set the maximum packet size to 9600, and “no
maximum-packet-length” will put it to factory default setting 1518.
20 port command
This command can be used to setup monitor function and security function on the
interface port(s).
(config-if)# port ?
monitor Monitors another interface
security
Specifies port security
port monitor ethernet 1/x rx command is used to add Port x to the monitored port
list. All the receive traffic from monited ports will be copied to the interface port(s).
“x” is the monitored port number. And no port monitor ethernet 1/x rx command
will remove Port x from monitored port list.
For example, “port monitor ethernet 1/2 rx” command will add Port 2 to the
monitored port list, and receive traffic to Port 2 will be copied to the interface port(s).
If current setup interface port is Port 5, Port 5 will be the monitoring port.
port security action command will set the interface port(s) to “accept” mode. In
“accept” mode, only devices/PC with static Mac addresses assigned on the interface
port(s) can access network through the interface port(s). Other devices/PC will be
rejected.
port security max-mac-count x command is used to set the maximum Mac address
number allowed on the interface port(s). “x” is the maximum number and its valid
value is 0-8192. For example, x=5 will allow up to five network devices / PC access
network through the interface port(s). And the port security will be set to this
operation mode with this command.
no port security command can be used to disable the security function on the
interface port(s).
21 port-vlan command
This command is used to assign the interface port(s) to a Port-based VLAN, and set the