Niveo Professional NGS16TP - Manual (Page 80)

76
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
Management VLAN : This is used to setup the VLAN ID for remote management interface
of the switch. Only users in the same VLAN can manage the switch remotely. For
example, setting it to “5” will allow users in the VLAN with VLAN ID 5 to manage the
switch remotely. It works only 802.1Q VLAN function is enable.
About DHCP Client [renew] and [release] button ...
[renew] button: If DHCP client function is enabled, you can click [renew] button to
refresh the lease time of the IP address. If IP configuration is not got when boot-up,
clicking [renew] button will try to get IP configuration again.
[release] button: If DHCP client function is enabled and IP configuration is got, clicking
[release] button will release current IP configuration. After that, you can click [renew]
button to get the IP configuration again.
3). Time Configuration
There are two ways to get the system time.
a). Get time from Time Server
This switch support NTP protocol to get time from Internet time server. For such
application, you have to select Get Time by “Time Server”, input the IP of Time Server,
and select the Time Zone of your location. Then click [Apply]
If time is got from Time Server, it will be shown at “Current Time”.
For such application, you have to get the IP of Time Server from your network
administrator first.
b). Set time manually
This switch can count time internal. You can select Get Time by “Manually”, and input
current time manually. Then click [Apply].
About [Daylight Saving Time] ...