Niveo Professional NGS16TP - Manual (Page 50)

46
NIVEO PROFESSIONAL Gigabit Management Switch
User's Manual
“no limit”.
rate-limit output level x command is used to specify the egress rate-limit level of the
interface port(s). “x” is the level number and its valid value is 0~31. If “x”=0, it means
“no limit”.
25 shutdown command
This command is used to disable the interface port(s).
shutdown command is used to disable the interface port(s).
no shutdown command is used to enable it.
26 spanning-tree command
This command is used to configure spanning tree function on interface port(s).
(config-if)# spanning-tree ?
cost
Specifies spanning tree cost
edge-port Specifies spanning tree edge port
port-priority Specifies spanning tree port priority
spanning-disabled Disables the spanning tree
spanning-tree cost x command is used to set spanning tree port path cost value on the
interface port(s). It is used to determine the best path between devices if looping
happens. Lower values will be forwarded and should be assigned to ports with fast
connections. Higher values will be blocked and should be assigned to ports with slow
connections. “x” is the cost value and its valid value is 1~65535. The suggestion
values are 100(50~600) for 10M, 19(10~60) for 100M and 4(3~10) for 1000M
connections.
spanning-tree edge-port command is used to set the interface port(s) as edge port.
And no spanning-tree edge-port command is used to set it as non-edge port. “Edge
port” means the interface port(s) are connected to end device(s) but not switch-to-
switch connection.
spanning-tree port-priority x command is used to set the spanning tree port priority
value on the interface port(s). “x” is the port-priority value and its valid value is 0~240.
If the path cost for all ports on a switch are the same, the port with the highest priority
(lowest value) will be forwarded when looping happens. If more than one port have
the same highest priority, the port with lowest port number will be forwarded.
spanning-tree spanning-disabled command is used to disable spanning tree function
on the interface port(s). And no spanning-tree spanning-disabled command will
enable it.
27 speed command
This command is used to set the operation speed of the interface port(s).
(config-if)# speed ?