Seaward Supernova XE - Manual (Page 63)

How to use Setup
53
Date & Time
This allows the user to password protect the date and time. An
existing password must be setup before this option can be used.
User List
This allows the user to password protect the User List. An existing
password must be setup before this option can be used.
Aplnce & Cmnts
This allows the user to limit the Appliance number and Comments
lines to 10 digits. When limited to 10 digits the Supernova XE can be
downloaded to a wider range of software. See Tips and
Troubleshooting for further details.
Change Password
It is possible to Password protect the Test Sequence Editor and the
System Configuration.
If you currently do not have password protection you will be asked to
enter a new password twice, once for confirmation.
If you currently do have password protection then you will be asked
for the old password before entering a new one, again you will be
asked for the new password twice.
To clear the password protection simply press Enter when asked for
the new password. A warning will show that no password is in place.
Set Brightness
You can now set the Brightness of the display. Use the cursor keys to
change the Brightness, once the Brightness is set press the Green
button to accept the changes. Press the Red button to abort any
changes made.
Factory Settings
It is possible to reset the Supernova XE to the settings which were
configured from new. This option will first ask you if you are sure,
select Yes to reset or No to abort.