H3C Technologies H3C WX3000E Series Wireless Switches User Manual
H3c wx series access controllers, Layer 2 configuration guide
Advertising
This manual is related to the following products:
H3C WX5500E Series Access Controllers, H3C WX3500E Series Access Controllers, H3C WX2500E Series Access Controllers, H3C WX6000 Series Access Controllers, H3C WX5000 Series Access Controllers, H3C LSWM1WCM10 Access Controller Module, H3C LSUM3WCMD0 Access Controller Module, H3C LSUM1WCME0 Access Controller Module, H3C LSWM1WCM20 Access Controller Module, H3C LSQM1WCMB0 Access Controller Module, H3C LSRM1WCM2A1 Access Controller Module, H3C LSBM1WCM2A0 Access Controller Module, H3C WA3600 Series Access Points, H3C WA2600 Series WLAN Access Points
Table of contents
Document Outline
- Title Page
- Preface
- Contents
- Configuring Ethernet interfaces
- Configuring loopback and null interfaces
- Configuring VLANs
- Configuring MAC address table
- Overview
- Configuring the MAC address table
- Displaying and maintaining MAC address tables
- MAC address table configuration example
- Configuring Ethernet link aggregation
- Overview
- Ethernet link aggregation configuration task list
- Configuring a Layer 2 static aggregation group
- Configuring an aggregate interface
- Configuring load sharing criteria for link aggregation groups
- Displaying and maintaining Ethernet link aggregation
- Layer 2 static aggregation configuration example
- Configuring spanning tree
- STP
- RSTP
- MSTP
- Protocols and standards
- Spanning tree configuration task list
- Setting the spanning tree mode
- Configuring an MST region
- Configuring the root bridge or a secondary root bridge
- Configuring the device priority
- Configuring the maximum hops of an MST region
- Configuring the network diameter of a switched network
- Configuring spanning tree timers
- Configuring the timeout factor
- Configuring the maximum port rate
- Configuring edge ports
- Configuring path costs of ports
- Configuring the port priority
- Configuring the port link type
- Configuring the mode a port uses to recognize/send MSTP packets
- Enabling outputting port state transition information
- Enabling the spanning tree feature
- Performing mCheck
- Configuring Digest Snooping
- Configuring No Agreement Check
- Configuring protection functions
- Displaying and maintaining the spanning tree
- MSTP configuration example
- Configuring Layer 2 forwarding
- Configuring PPP
- Overview
- Configuring PAP authentication
- Configuring CHAP authentication
- Configuring MS-CHAP or MS-CHAP-V2 authentication
- Configuring PPP negotiation
- Enabling PPP traffic statistics collection
- Displaying and maintaining PPP
- Troubleshooting PPP configuration
- Configuring PPPoE
- Configuring QinQ
- Configuring VLAN termination
- Index