Configuring an mst region – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 76
66
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Set the spanning tree mode.
stp mode { stp | rstp | mstp }
MSTP mode by default.
NOTE:
Whether you need to specify the MSTI for the spanning tree configuration varies with the spanning tree
modes.
•
In STP-compatible or RSTP mode, do not specify any MSTI. Otherwise, the spanning tree configuration
is ineffective.
•
In MSTP mode, if you specify an MSTI, the spanning tree configuration is effective for the specified MSTI.
If you do not specify any MSTI, the spanning tree configuration is effective for the CIST.
Configuring an MST region
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter MST region view.
stp region-configuration
N/A
3.
Configure the MST region
name.
region-name name
Optional.
The MST region name is the MAC
address by default.
4.
Configure the
VLAN-to-instance mapping
table.
instance instance-id vlan vlan-list
Optional.
Use either command.
All VLANs in an MST region are
mapped to the CIST (or MSTI 0) by
default.
vlan-mapping modulo modulo
5.
Configure the MSTP revision
level of the MST region.
revision-level level
Optional.
0 by default.
6.
Display the MST region
configurations that are not
activated yet.
check region-configuration
Optional.
7.
Activate MST region
configuration manually.
active region-configuration
N/A
8.
Display the activated
configuration information of
the MST region.
display stp region-configuration [ |
{ begin | exclude | include }
regular-expression ]
Optional.
Available in any view.