H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 58
48
# Assign ports GigabitEthernet 1/0/1 through GigabitEthernet 1/0/2 to link aggregation group
1.
[AC1] interface gigabitethernet 1/0/1
[AC1-GigabitEthernet1/0/1] port link-aggregation group 1
[AC1-GigabitEthernet1/0/1] quit
[AC1] interface gigabitethernet 1/0/2
[AC1-GigabitEthernet1/0/2] port link-aggregation group 1
[AC1-GigabitEthernet1/0/2] quit
# Configure Layer 2 aggregate interface Bridge-Aggregation 1 as a trunk port and assign it to
VLANs 10 and 20.
[AC1] interface bridge-aggregation 1
[AC1-Bridge-Aggregation1] port link-type trunk
[AC1-Bridge-Aggregation1] port trunk permit vlan 10 20
Please wait... Done.
Configuring GigabitEthernet1/0/1... Done.
Configuring GigabitEthernet1/0/2... Done.
[AC1-Bridge-Aggregation1] quit
# Configure AC 1 to use the source and destination MAC addresses of packets as the global
link-aggregation load sharing criteria.
[AC1] link-aggregation load-sharing mode source-mac destination-mac
2.
Configure AC 2 in the same way as you configure AC 1.
3.
Verify the configurations:
# Display summary information about all aggregation groups on AC 1.
[AC1] display link-aggregation summary
Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
AGG Select Unselect Share
Interface Ports Ports Type
--------------------------------------------------------------------------------
BAGG1 2 0 Shar
The output shows that link aggregation group 1 is a load shared Layer 2 static aggregation group
and it contains two Selected ports.
# Display the global link-aggregation load sharing criteria on AC 1.
[AC1] display link-aggregation load-sharing mode
Link-Aggregation Load-Sharing Mode:
destination-mac address, source-mac address
The output shows that all link aggregation groups created on the device perform load sharing
based on source and destination MAC addresses.