Network requirements, Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 27
17
Hardware
Ethernet interface configuration prerequisites
LSQM1WCMB0
LSQM1WCMD0
LSBM1WCM2A0
LSRM1WCM2A1
LSRM1WCM3A1
You configure Ethernet interfaces on the switch.
NOTE:
To log in to the access controller module from the switch, use the oap connect
slot
slot-number
command.
LSWM1WCM10
LSWM1WCM20
You configure Ethernet interfaces on the switch.
NOTE:
To log in to the access controller module from the switch, use the oap connect
slot 1
slot-number
system
system-name
command.
Wireless switches
WX3024E
Use the oap connect slot 0 command on the access controller engine to log
in to the switching engine.
Access controllers
WX6103
Use the oap connect slot 0 command on the active main control board to log
in to the switch interface board.
WX5002
WX5004
You configure GE interfaces on the access controller.
Network requirements
As shown in
, PC A is assigned to VLAN 5. PC B is assigned to VLAN 10. The PCs belong to
different IP subnets and cannot communicate with each other.
Configure VLAN interfaces on the AC and configure the PCs to enable Layer 3 communication between
the PCs.
Figure 5 Network diagram
Configuration procedure
1.
Configure the AC:
# Create VLAN 5 and assign GigabitEthernet 1/0/1 to it.
<AC> system-view
[AC] vlan 5
[AC-vlan5] port gigabitethernet 1/0/1
# Create VLAN 10 and assign GigabitEthernet 1/0/2 to it.
[AC-vlan5] vlan 10