H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 33)

23
Step Command Remarks
2. Enter interface view or port
group view.
• Enter WLAN-ESS or
Ethernet interface view:
interface interface-type
interface-number
• Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
• Enter port group view:
port-group manual
port-group-name
Use any command.
• The configuration made in
WLAN-ESS or Ethernet interface
view applies only to the port.
• The configuration made in port
group view applies to all ports in the
port group.
• The configuration made in Layer 2
aggregate interface view applies to
the aggregate interface and its
aggregation member ports. If the
system fails to apply the
configuration to the aggregate
interface, it stops applying the
configuration to aggregation
member ports. If the system fails to
apply the configuration to an
aggregation member port, it skips
the port and moves to the next
member port.
3. Configure the link type of the
ports as hybrid.
port link-type hybrid N/A
4. Assign the hybrid ports to the
specified VLANs. port hybrid vlan vlan-id-list
{ tagged | untagged }
By default, a hybrid port allows only
packets of VLAN 1 to pass through
untagged.
5. Configure the PVID of the
hybrid port.
port hybrid pvid vlan vlan-id
Optional.
By default, the PVID is VLAN 1.
NOTE:
•
To change the link type of a port from trunk to hybrid or vice versa, you must set the link type to access
first.
• Before assigning a hybrid port to a VLAN, create the VLAN first.
• After configuring the PVID for a hybrid port, you must use the port hybrid vlan command to configure
the hybrid port to allow packets from the PVID to pass through, so that the egress port can forward
packets from the PVID.
Port-based VLAN configuration example
Network requirements
NOTE:
•
The configuration examples were created on a WX5004 access controller and may vary with device
models.Check Table 3 to see where you configure Ethernet interfaces.