Configuring the authenticatee – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 108
98
Step
Command
Remarks
10.
Create an ISP domain, or
enter an existing ISP domain
view.
domain isp-name
Optional.
To configure the ppp
authentication-mode command
with an ISP domain specified
which is not the default domain
system, configure this command
before configuring the ppp
authentication-mode command.
11.
Configure local authentication
for the PPP users.
authentication ppp local
Optional.
For more information about local user configuration and domain configuration, see Security
Configuration Guide.
Configuring the authenticatee
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Create a VT interface and
enter its view.
interface virtual-template
interface-number
N/A
3.
Assign a username to the
CHAP authenticatee.
ppp chap user username
The username you assign to the
authenticatee here must be the
same as the local username you
assign to the authenticatee on the
authenticator.
4.
Return to system view.
quit
N/A
5.
Create a local user account
for the authenticator and
enter local user view.
local-user username
For more information about local
user configuration, see Security
Configuration Guide.
6.
Set the password for the local
user.
password { cipher | simple }
password
The password of the authenticator
user must be the same as that of
the authenticatee user.
7.
Configure the service type of
the local user as PPP.
service-type ppp
N/A
NOTE:
If the authenticator name is configured, do not configure the ppp chap password command on the
interface that connects the authenticatee. Otherwise, the authentication may fail.