Network requirements, Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 47
37
Hardware
Ethernet interface configuration prerequisites
LSQM1WCMB0
LSQM1WCMD0
LSBM1WCM2A0
LSRM1WCM2A1
LSRM1WCM3A1
You configure Ethernet interfaces on the switch.
NOTE:
To log in to the access controller module from the switch, use the oap connect
slot
slot-number
command.
LSWM1WCM10
LSWM1WCM20
You configure Ethernet interfaces on the switch.
NOTE:
To log in to the access controller module from the switch, use the oap connect
slot 1
slot-number
system
system-name
command.
Wireless switches
WX3024E
Use the oap connect slot 0 command on the access controller engine to log
in to the switching engine.
Access controllers
WX6103
Use the oap connect slot 0 command on the active main control board to log
in to the switch interface board.
WX5002
WX5004
You configure GE interfaces on the access controller.
Network requirements
As shown in
:
•
The MAC address of Host A is 000f-e235-dc71 and belongs to VLAN 1. It is connected to
GigabitEthernet 1/0/1 of the device. To prevent MAC address spoofing, add a static entry to the
MAC address table of the device for the host.
•
The MAC address of Host B is 000f-e235-abcd and belongs to VLAN 1. Because this host once
behaved suspiciously on the network, you can add a destination blackhole MAC address entry for
the MAC address to drop all packets destined for the host.
•
Set the aging timer for dynamic MAC address entries to 500 seconds.
Figure 9 Network diagram
Configuration procedure
# Add a static MAC address entry.