Assigning a trunk port to a vlan – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 31
21
Step Command
Remarks
2.
Enter interface
view or port group
view.
•
Enter WLAN-ESS or Ethernet
interface view:
interface interface-type
interface-number
•
Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
•
Enter port group view:
port-group manual
port-group-name
Use any command.
•
The configuration made in WLAN-ESS or
Ethernet interface view applies only to the
port.
•
The configuration made in port group view
applies to all ports in the port group.
•
The configuration made in Layer 2 aggregate
interface view applies to the aggregate
interface and its aggregation member ports.
If the system fails to apply the configuration to
the aggregate interface, it stops applying the
configuration to aggregation member ports.
If the system fails to apply the configuration to
an aggregation member port, it skips the port
and moves to the next member port.
3.
Configure the link
type of the port or
ports as access.
port link-type access
Optional.
By default, the link type of a port is access.
4.
Assign the current
access ports to a
VLAN.
port access vlan vlan-id
Optional.
By default, all access ports belong to VLAN 1.
NOTE:
•
Before assigning an access port to a VLAN, create the VLAN first.
•
In VLAN view, only Layer 2 Ethernet interfaces can be assigned to the current VLAN.
Assigning a trunk port to a VLAN
A trunk port can carry multiple VLANs. You can assign it to a VLAN in interface view (including Ethernet
interface view and Layer 2 aggregate interface view) or port group view.
To assign a trunk port to one or multiple VLANs:
Step Command
Remarks
1.
Enter system view.
system-view
N/A