HEIDENHAIN TNC 310 (286 140) - Manual (Page 158)

8 Programming: Cycles 146
X
Y
Z
8.7 Special Cycles
ORIENTED SPINDLE STOP (Cycle 13)
The TNC and the machine tool must be specially
prepared by the machine tool builder for the use
of Cycle 13.
The control can address the machine tool spindle as a 4th axis and
rotate it to a given angular position.
Oriented spindle stops are required for
■ Orientation of the transmitter/receiver window of HEIDENHAIN
3-D touch probes with infrared transmission
Function
The angle of orientation defined in the cycle is positioned to by
entering M19.
If you program M19 without having defined Cycle 13, the TNC
positions the machine tool spindle to an angle that has been set in
a machine parameter (see your machine manual).
ú Angle of orientation: Enter the angle according to
the reference axis of the working plane.
Input range0 to 360°
Input resolution 0.1°