HEIDENHAIN TNC 310 (286 140) - Manual (Page 9)

Contents
Contents VI
7 PROGRAMMING: MISCELLANEOUS FUNCTIONS.....85
7.1 Entering Miscellaneous Functions M and STOP.....86
7.2 Miscellaneous Functions for Program Run Control, Spindle and Coolant.....87
7.3 Miscellaneous Functions for Coordinate Data.....87
7.4 Miscellaneous Functions for Contouring Behavior.....89
7.5 Miscellaneous Function for Rotary Axes.....92
8 PROGRAMMING: CYCLES.....93
8.1 General Overview of Cycles.....94
8.2 Drilling Cycles.....96
PECKING (Cycle 1).....96
DRILLING (Cycle 200).....98
REAMING (Cycle 201).....99
BORING (Cycle 202).....100
UNIVERSAL DRILLING (Cycle 203).....101
BACK BORING (Cycle 204).....103
TAPPING with a floating tap holder (Cycle 2).....105
RIGID TAPPING (Cycle 17).....106
Example: Drilling cycles.....107
Example: Drilling cycles .....108
8.3 Cycles for Milling Pockets, Studs and Slots.....109
POCKET MILLING (Cycle 4).....110
POCKET FINISHING (Cycle 212).....111
STUD FINISHING (Cycle 213).....113
CIRCULAR POCKET MILLING (Cycle 5).....114
CIRCULAR POCKET FINISHING (Cycle 214).....116
CIRCULAR STUD FINISHING (Cycle 215) .....117
SLOT MILLING (Cycle 3).....119
SLOT with reciprocating plunge-cut (Cycle 210).....120
CIRCULAR SLOT with reciprocating plunge-cut (Cycle 211) .....122
Example: Milling pockets, studs and slots.....124