HEIDENHAIN TNC 310 (286 140) - Manual (Page 236)

14 Tables and Overviews 224
14.1 Gener
al User P
ar
a
met
ers
14.1 Gener
al User P
ar
a
met
ers
Graphic display mode
MP7310
Projection in three planes according to ISO 6433,
projection method 1: +0
Projection in three planes according to ISO 6433,
projection method 2: +1
Do not rotate coordinate system for graphic display: +0
Rotate coordinate system for graphic display by 90°: +2
Machining and program run
Cycle 17: Oriented spindle stop at beginning of cycle
MP7160
Spindle orientation: 0
No spindle orientation: 1
Effect of Cycle 11 SCALING FACTOR
MP7410
SCALING FACTOR effective in 3 axes: 0
SCALING FACTOR effective in the working plane only: 1
Cycle 4 POCKET MILLING and Cycle 5 CIRCULAR POCKET MILLING: Overlap factor
MP7430
0.1 to 1.414
Behavior of M functions
MP7440
Program stop with M06: +0
No program stop with M06: +1
No cycle call with M89: +0
Cycle call with M89: +2
Program stop for M functions: +0
No program stop for M functions: +4
Do not set axis-in-position marker for waiting time between two NC
blocks: +0
Set axis-in-position marker for waiting time between two NC blocks: +32
Angle of tool-path directional change up to which the feed rate will remain constant
(applies for radius-compensated inside corners and corners with R0)
This feature works both during operation with servo lag as well as with
velocity feedforward.
MP7460
0.000 to 179.999 [°]
Maximum contouring speed at a feed rate override setting of 100% in the program run modes
MP7470
0 to 99 999 [mm/min]
Datums from a datum table are referenced to the
MP7475
Workpiece datum: +0
Machine datum: +1