HEIDENHAIN TNC 310 (286 140) - Manual (Page 28)

16
2
.2
M
o
v
in
g
t
h
e
M
a
c
hine
A
x
e
s
2 Manual Operation and Setup
Traversing with the HR 410 electronic handwheel
The portable HR 410 handwheel is equipped with two permissive
buttons. The permissive buttons are located below the star grip.
You can only move the machine axes when an permissive button is
depressed (machine-dependent function).
The HR 410 handwheel features the following operating elements:
EMERGENCY STOP
Handwheel
Permissive buttons
Axis address keys
Actual-position-capture key
Keys for defining the feed rate (slow, medium, fast; the feed rates
are set by the machine tool builder)
Direction in which the TNC moves the selected axis
Machine function
(set by the machine tool builder)
The red indicators show the axis and feed rate you have selected.
To move an axis:
Select the Manual Operation mode.
<
Activate handwheel, set soft key to ON
<
Press the permissive button.
<
Select the axis on the handwheel
<
Select the feed rate.
<
or Move the active axis in the positive or negative
direction.