HEIDENHAIN TNC 310 (286 140) - Manual (Page 235)

223 HEIDENHAIN TNC 310
14.1 Gener
al User P
ar
a
met
ers
Manual Operation mode: Display of feed rate
MP7270
Display feed rate F only if an axis direction button is pressed: +0
Display feed rate F even if no axis direction button is pressed (feed
rate of the „slowest“ axis): +1
Spindle speed S and miscellaneous function M effective
after STOP: +0
Spindle speed S and miscellaneous function M no longer effective
after STOP: +2
Display of gear range
MP7274
Do not display current gear range: 0
Display current gear range: 1
Decimal character
MP7280
The decimal character is a comma: 0
The decimal character is a point: 1
Position display in the tool axis
MP7285
Display is referenced to the tool datum: 0
Display in the tool axis is referenced
to the tool face: 1
Display step for the X axis
MP7290.0
0.1 mm or 0.1°: 0
0.05 mm or 0.05°: 1
0.01 mm or 0.01°: 2
0.005 mm or 0.005°: 3
0.001 mm or 0.001°: 4
Display step for the Y axis
MP7290.1
see MP 7290.0
Display step for the Z axis
MP7290.2
see MP 7290.0
Display step for the IVth axis
MP7290.3
see MP 7290.0
Reset status display, Q parameters and tool data
MP7300
Do not cancel Q parameters and status display: +0
Q parameters and status display with M02, M30, END PGM: +1
After a power interruption do not activate tool data that
was last active: +0
After a power interruption re-activate tool data that was last active: +4