HEIDENHAIN TNC 310 (286 140) - Manual (Page 208)

11 Test Run and Program Run 196
1
1
.3 Pr
ogr
am Run
Resuming program run with the NC START button
You can resume program run by pressing the NC START button if
the program was interrupted in one of the following ways:
■ NC STOP button was pressed
■ A programmed interruption
■ The EMERGENCY STOP button was pressed (machine-dependent
function)
If you interrupted program run with the STOP soft key,
you can select another block with the GOTO key and
resume machining there.
If you select block 0, the TNC resets all stored data (tool
data, etc.)
If you interrupted program run during a program section
repeat, you can only use GOTO to select other blocks
within the program section repeat.
Resuming program run after an error
■ If the error message is not blinking
ú Remove the cause of the error.
ú To clear the error message from the screen, press the CE key.
ú Restart the program, or resume program run at the place at which
it was interrupted.
■ If the error message is blinking
ú Switch off the TNC and the machine.
ú Remove the cause of the error.
ú Start again.
If you cannot correct the error, write down the error message and
contact your repair service agency.