HEIDENHAIN TNC 310 (286 140) - Manual (Page 203)

191 HEIDENHAIN TNC 310
11
.2
T
est
Run
Running a program test
ú Select the PROGRAM RUN operating mode
ú Select the TEST RUN mode of operation.
ú Call the file manager with the PGM NAME key and
select the file you wish to test, or
ú Go to the program beginning: Select line “0” with
the GOTO key and confirm you entry with the ENT
key.
The TNC displays the following soft keys (1st or 2nd soft-key row):
Function Soft key
Test the entire program
Test each program block individually
Show the blank form and test the entire program
Interrupt the test run
Running a program test up to a certain block
With the STOP AT N function the TNC does a test run up to the
block with block number N.
ú Go to the beginning of program in the Test Run mode of
operation.
ú To do a test run up to a certain block, press the STOP AT N soft
key.
ú Up to block number =: Enter the number of the
block at which the test run should stop.
ú Program: If you wish to go into a program that you
have called with Cycle 12 PGM CALL, enter the
number of the program containing the block with
the selected block number.
ú Repetitions: If the block number is located in a
program section repeat, enter the number of
repeats that you want to run.
ú To test a program section, press the START soft
key. The TNC will test the program up to the
entered block.