HEIDENHAIN TNC 310 (286 140) - Manual (Page 178)

10 Programming: Q Parameters 166
1
0.6 Chec
king and Changing Q P
a
ra
met
ers
Abbreviations used:
IF
If
EQU Equals
NE Not equal
GT Greater than
LT Less than
GOTO Go to
10.6 Checking and Changing
Q Parameters
During a program run or test run, you can check or change Q
parameters if necessary.
ú If you are in a program run, interrupt it (for example by pressing the
machine STOP button and the STOP soft key). If you are doing a
test run, interrupt it.
ú To call the Q parameter table, press the
PARAMETER TABLE soft key.
ú Using the arrow keys you can select a Q-parameter
on the current screen page. You can go to the next
or the previous screen page using the PAGE soft
keys.
ú If you wish to change the value of a parameter,
enter a new value, confirm it with the ENT key and
conclude your entry with the END key.
To leave the value unchanged, terminate the dialog
with the END key.