3 cr eating and w riting pr ogr ams – HEIDENHAIN TNC 310 (286 140) User Manual
Page 47
Advertising
35
HEIDENHAIN TNC 310
Creating a new part program
You always enter a part program in the Programming and Editing
mode of operation.
Program initiation in an example:
Select the Programming and Editing mode of
operation.
<
Call up the file manager: Press the PGM NAME
soft key
File name =
<
3056
Enter the new program number and confirm
your entry with the ENT key.
File name = 3056.H
<
Select the default setting for unit of
measurement (mm): Press the ENT key, or
Switch to inches: Press the MM/INCH soft key
and confirm with ENT.
4.3 Cr
eating and
W
riting Pr
ogr
ams
Advertising
This manual is related to the following products: