RIGOL DSA875 - Manual (Page 205)

Chapter 4 Troubleshooting&Message RIGOL
User’s Guide for DSA800 Series 4-13
Execution Error
Number Message Description
-200
Execution error.
A generic syntax error indicates that the device cannot detect more
specific errors. This code indicates that only an Execution Error defined in
IEEE 488.2, 11.5.1.1.5 has occurred.
-201 Invalid while in local.
Indicate that a command is not executable while the device is in local
mode (see IEEE 488.2, 5.6.1.5); select a proper communication interface
to switch to remote mode.
-203 Command protected.
Indicate that a legal password-protected program command or query
could not be executed because the command was disabled.
-220 Parameter error.
Indicate that a program data element related error occurred. This error
message is always used when the device cannot detect the more specific
errors described in errors -221 to -229.
-221 Settings conflict.
Indicate that a legal program data element was parsed but could not be
executed due to the current device state (see IEEE 488.2, 6.4.5.3 and
11.5.1.1.5.)
-222 Data out of range.
Indicate that a legal program data element was parsed but could not be
executed because the interpreted value was outside of the legal range
defined by the device (see IEEE 488.2, 11.5.1.1.5.)
-223 Too much data.
Indicate that a legal program data element of block, expression or string
type was received but could not be executed because it contained more
data than the device could handle due to memory or related device
requirements.
-224 Illegal parameter value.
Used where the specified value in the parameter list was expected.
-225 Out of memory.
The device has insufficient memory to perform the requested operation.
-233 Invalid version.
Indicate that a legal program data element was parsed but could not be