TA Triumph-Adler CX 8682 - Manual (Page 18)

CHAPTER 3 PREPARATIONS
3-2
2
1
● Do not use the following originals.
• Originals of sizes other than the sizes described as acceptable
originals
• Originals with staples or clips
• Wet originals or originals with adhesive tape, or glue
• Originals with uneven thickness
• Original wet with ink or correction fluid
For originals processed around the edges, the leading and trailing
edges are wavy. Images in these areas may be isolated or missing. In
this case, set the original so that the edge that is less wavy is placed
as the leading edge.
(2) Setting the Original Loop Guide
The original loop guide returns the originals ejected to the rear of the
machine toward the front side.
* When using an original tray (option) or a carrier sheet (option) and
when “ 6 Orig.eject direct” of the default setting is set to “Discharge
to front”[Output to front], remove the original loop guide.
(3) Setting the Original Holders
When copying a long rolled original, open the original holders on both
sides and use them.
Set an original face down. When automatic start is activated
or you press the Start key, scanning of the original will start.
Release the original when scanning starts.
Set the guide on the rear side of the machine.
(4) How to Set an Original
Adjust both the original guides to the original size indications
on the original table.
NOTE
• When using an original of which the leading edge is easily curled,
the leading edge may be broken. Take care when using such
original.
• The method of starting copying varies with the “ @ Method of copy
start” of the default setting. (Page 7-5)
• To scan an original with precision, open the original leading edge cover
and place the original. See “ ● Setting the original with precision” .