TA Triumph-Adler CX 8682 - Manual (Page 94)

CHAPTER 8 TROUBLESHOOTING
8-12
1
2
3
4
5
6
7
Open the front cover.
Grasp the handles A of the roll unit to unlock the unit and
pull out the roll unit until it stops.
Grasp the flange and rewind the paper roll.
If there is any wrinkled or folded area, remove it with a
cutting knife or scissors.
Grasp both of the paper roll insertion latches 3 and open
the paper roll insertion cover 4 .
Insert the leading edge of the paper back under the paper
roll insertion guide and pull the edge out approximately 1/2"
[10 mm] from the guide as shown in the illustration.
Grasp both of the paper roll insertion latches and close the
paper roll insertion cover.
IMPORTANT
• If the paper roll that has been set is slack, grasp the flange and
rewind the paper roll to clear the slack. If not, paper may be fed
obliquely.