TA Triumph-Adler CX 8682 - Manual (Page 21)

CHAPTER 3 PREPARATIONS
3-5
2. Paper
(1) Paper Types
Note the following restrictions on paper that can be used in this
machine.
● Acceptable paper
1. Paper source 1 (option), paper source 2, and paper source 3
• Paper roll width: 17" to 36" [210 to 920 mm]
• Paper roll outer diameter: 6 3/4" [180 mm] or less
• Paper roll inner diameter: 3" [76 mm (75.2 to 77.2 mm)]
• Acceptable paper roll types
Plain paper (64 to 80 g/m 2 )
Vellum
Film
2. Bypass
Paper sizes (standard paper): 8 1/2" x 11" to 36" x 48" [A4 portrait
to A0]
Paper width: 17" to 36" [210 to 920 mm]
Paper length: 11" to 48" [297 to 1189 mm]
Acceptable paper materials
Plain paper (64 to 80 g/m 2 )
Vellum
Film
● Unacceptable paper
• Paper other than the paper described in “ ● Acceptable paper”
• Paper with staples, etc.
• If paper is wrinkled, folded or broken, pull the paper roll until the
problem disappears and cut the paper before using it.
● Automatic paper width detection
If the paper roll that has been set is of a standard size, the paper
width will be automatically detected. The following sizes can be
detected.
Metric machine
<A sizes>
A0: 841 mm
A1: 594 mm
A2: 420 mm
A3: 297 mm
A4: 210 mm
<B sizes>
B1: 728 mm
B2: 515 mm
B3: 364 mm
B4: 257 mm Inch machine
<Architecture>
36"
24"
18"
14"
<Engineering>
34"
22"
17"
11"
NOTE
• Automatic detection will not function for the bypass.
• Paper width of non-standard sizes can be registered. See “
1 Paper
width adjustment” of the default setting. (Page 7-1)
• For switching of standard size (architecture/engineering [A sizes/ B
sizes]), select in “ # Standard size set” of the default setting.
(Page 7-3)
● Storage of paper
If the machine is not used for an extended period time, remove the
paper roll and return it to its original package and reseal it.
IMPORTANT
• Vellum
Since vellum is very susceptible to environment, when it is not used,
put it in a plastic bag and seal it.
• When using vellum at a high humidity or at a low temperature,
vellum will become fragile, resulting in wrinkles of copies or missing
of images. If images are not properly copied, perform the following
procedure.
* When using cut vellum:
Change the orientation of paper (portrait or landscape).
* When using vellum roll:
Pull out the paper roll by length of approximately one turn and cut the
paper before using it.
• When using paper roll with adhesive substance, remove the
adhesive substance or pull out the paper roll until the attached
adhesive substance is not seen and then cut the paper before using
it.