TA Triumph-Adler CX 8682 - Manual (Page 84)

CHAPTER 8 TROUBLESHOOTING
8-2
“No roll unit” [“Roll unit is not set.”] A roll unit is not securely inserted. Open the front cover and
push the roll unit in securely.
“Add Paper in X Drawer.” Paper with different width is set for interrupt copy or job
reserve. Replace the paper roll.
“Check waste toner tank.” The waste toner tank is full or the tank is not properly installed.
Replace it with a new tank or install the tank properly.
“Add toner to resume copying.” If this message is displayed with “Ready to copy.”, copying can
be performed but continuous copying is not possible. Replen-
ish toner promptly. Copying can be performed for some time
but when only this message is displayed, copying cannot be
performed.
“Time for Maintenance” Maintenance of the machine is needed. Contact your service
representative.
“Call for service.” A problem has occurred inside the main body. See
“5. Countermeasures against Call for service Message”.
“Memory full” Memory overflow has occurred. See “4. Countermeasures
against Memory Overflow.”
“Could not be saved.” Original images cannot be saved in memory. Copying of
second original and after or repeat copy cannot be performed.
See “4. Countermeasures against Memory Overflow.”
“Exceeding zoom range. Reenter zoom ratio.” The magnification ratio or another setting for editing functions
exceeds the specified limit. Press the OK key and then enter
the value again.
“These functions cannot be combined.” A function or a default setting that cannot be set now is
accessed. See “List of Default Setting”.
“Pin code is different” The password is not correct. Use the numeric keys to enter the
correct password.
“Repeat copy code is wrong.” The repeat copy code is not correct. Use the numeric keys to
enter the correct code.
“Insert key counter.” The key counter (option) is not set or not properly set. Set the
counter properly.
Message Countermeasures Page
3-6
3-6
8-5
8-3
–
8-8
8-6
8-6
–
7-1
7-3
7-6
4-1