TA Triumph-Adler CX 8682 - Manual (Page 91)

CHAPTER 8 TROUBLESHOOTING
8-9
(Inch)
(Metric)
(Inch)
(Metric)
1
WARNING
High voltage is present in the charger section. Take sufficient
care when working in this area, as there is a danger of
electrical shock.
CAUTION
The copier's fixing unit is extremely hot. Take sufficient care
when working in this area, as there is a danger of getting
burned.
1
2
3
6. When Paper or an Original Jams
When paper or an original jams, copying will stop and a message indicating a jam will appear. Keep the main power switch on ( ❘ ) and remove the
jammed paper in accordance with the message.
(1) Jam location display
1 Jam in the machine
2 Jam in the bypass slot (Page 8-11)
3 Jam in the paper feed section (Page 8-11)
● Jam in the original cover (Page 8-13)
(2) Cautions
• Do not reuse any paper that has jammed.
• If the jammed paper tears during removal, make sure not to leave
any pieces inside the machine as this would cause another jam.
• After removal of jammed paper or original, warm up will begin, the
message will go out, and the machine will return to the settings
before the jam has occurred.
(3) Removal procedure
1 If “Paper misfeed. Press “Cut paper” key.” or “Paper misfeed. Pull
out original table. “ appears:
Paper has jammed in the machine. Perform the following procedure
to remove the jammed paper.
If “Press “Cut paper” key.” appears, press the Roll Cut key.
IMPORTANT
• Do not open any cover before pressing the Roll Cut key.