TA Triumph-Adler CX 8682 - Manual (Page 93)

CHAPTER 8 TROUBLESHOOTING
8-11
8
9
(Inch)
(Metric)
1
WARNING
High voltage is present in the charger section. Take sufficient
care when working in this area, as there is a danger of
electrical shock.
2
3
(Inch)
(Metric)
4
Grasp the ejection release lever and close the ejection cover.
Grasp the main body release lever and push the original
table toward the rear side of the machine to close securely
the main body.
2 If “Paper misfeed. Remove paper. “ appears:
Paper has jammed in the bypass slot. Perform the following
procedure to remove the jammed paper.
Pull out the paper jammed in the bypass slot toward you.
* If the jammed paper is difficult to remove, do not pull too
hard but simply proceed to the next step.
Grasp the main body release lever and pull it toward you.
The main body will be opened.
If the paper is seen, remove it from inside the machine.
* If the jammed paper is difficult to remove, do not pull too
hard but simply proceed to the next step.
Grasp the main body release lever and push the original
table toward the rear side of the machine to close securely
the main body.
3 If “Paper misfeed. Open front cover.” appears:
Paper roll has jammed in the indicated paper source.
Perform the following procedure to remove the jammed paper.