Canon EOS C200 EF Cinema Camera and 24-105mm Lens Kit - Manual (Page 145)

145
Connecting to an External Monitor or Recorder
Options
1
Available only for output from the VIDEO terminal and the camera’s viewfinder (
k
only).
2 Only when [ ! Custom Picture/HDR ] > [Preset] is set to [Canon Log 3]. Available only for SDI output.
NOTES
• When you apply the [LUT: ACESproxy] LUT to the SDI terminal, it will output ACESproxy video data. Using a
compatible monitor, you can perform on-set color grading and check the image after color correction as you
continue shooting.
• If you set an assignable button to [LUT] ( A 119), you can press the button to turn on and off the LUTs applied
to all output terminals/screens at once.
• If you change the > [ ! Custom Picture/HDR] > [Preset] or [Gamma] setting, the LUT will be
deactivated and all the terminals’ output settings will be reset to [LUT: Off].
Superimposing Onscreen Displays on Screens/Video Outputs
You can choose to superimpose onscreen displays on the video output from the SDI terminal or HDMI OUT
terminal. Doing so will display the onscreen displays on an external monitor. This setting will not affect your
recordings.
1 Open the [OSD Output] submenu.
> [ ¢ % Monitoring Setup]
1 > [OSD Output]
1 l Appears on the previous page in the menu.
2 Select [On] and then press the joystick.
• In mode, T appears on the right of the screen (only if [ ¢ % Monitoring Setup] > [Custom
Display 2] > [OSD Output] is set to [On]). In mode, the icon appears at the top of the screen in the
playback screen.
NOTES
• When the video output from the HDMI OUT terminal is 4K (3840x2160) recorded at 59.94P or 50.00P, the
onscreen displays will be superimposed on the video.
• If you set an assignable button to [OSD Output] ( A 119), you can press the button to turn on and off the
superimposing of onscreen displays on video output.
Applied LUT
Output Settings with LUT applied
Description
Gamma curve Color space
[LUT: BT.709] Wide DR BT.709
LUT for viewing on the screen or external monitors compatible with BT.709
specifications.
[LUT: HDR Assist. (1600%)]
1
,
[LUT: HDR Assist. (400%)] 1
Original gamma
curve
BT.709
LUT for viewing HDR (high dynamic range) images on monitoring devices
connected to the VIDEO terminal. The LUT follows the BT.2100 transfer
function to convert a brightness range of 1600% or 400% respectively into
output the same as video displayed on an HDR-compatible display.
[LUT: ACESproxy]
2
ACESproxy ACESproxy
LUT for viewing on external monitors compatible with the ACESproxy
standard established by ACES (Academy Color Encoding System). The signal
output will use full range coding.
[LUT: Off] – – No LUT applied.
Operating modes: