Canon EOS C200 EF Cinema Camera and 24-105mm Lens Kit - Manual (Page 155)

155
Connecting to a Wi-Fi Network
Manual Setup
If you prefer, you can enter manually the details of the Wi-Fi network you want to connect to. Follow the
instructions on the screen to complete the procedure.
1 To enter the [SSID] (network name), select [Input] and then press the joystick.
• Enter the SSID (network name) of the selected Wi-Fi network using the keyboard screen ( A 35).
• The network name is needed to connect the network device to the camera. If necessary, write it down.
• After entering the network name, select [OK] and then press the joystick.
2 Select the Wi-Fi network’s authentication method and then press the joystick.
• If you selected [Shared Key], skip to step 4.
3 Select the Wi-Fi network’s encryption method and then press the joystick.
• If the authentication method is [Open], you can select [WEP] and continue to step 4, or [No Encryption] and
skip to step 6.
• If the authentication method is [WPA-PSK] or [WPA2-PSK], you can select [TKIP] or [AES].
4 If necessary, select the WEP index key.
5 To enter the [Encryption Key] (password), select [Input] and then press the joystick.
• Enter the password of the selected Wi-Fi network using the keyboard screen ( A 35).
6 Continue with the procedure to configure the IP address assignment ( A 151).
NOTES
Valid passwords vary depending on the encryption method.
64-bit WEP encryption: 5 ASCII characters or 10 hexadecimal characters.
128-bit WEP encryption: 13 ASCII characters or 26 hexadecimal characters.
AES / TKIP encryption: 8 to 63 ASCII characters or 64 hexadecimal characters.
* Note: ASCII characters include the numbers 0 to 9, the letters a to z and A to Z and some punctuation marks and special
symbols. Hexadecimal characters comprise the numbers 0 to 9 and the letters a to f and A to F.