Recording, Recording 56 – Canon EOS C200 EF Cinema Camera and 24-105mm Lens Kit User Manual
Page 56
Recording Video
56
Recording
1 Set the
Q
switch to CAMERA.
• The camera turns on in
mode and enters record standby mode.
• The access indicators of card slots with a card inserted will illuminate momentarily in red. Then, the access
indicator of the recording media slot selected for recording will change to green.
2 Press the REC button to begin recording.
• Recording starts. The tally lamps illuminate and the recording indicator [
Ü
REC] appears at the top of the
screen.
• You can use the REC button on the camera’s body (left side) or camera grip.
• You can also perform this function remotely using Browser Remote on a connected network device (
A
• For details about recording proxy clips, refer to
Simultaneous Recording of Proxy Clips
(
A
3 Press the REC button to stop recording.
• The clip is recorded and the camera enters record standby mode. The tally lamp will also go out.
IMPORTANT
• Observe the following precautions while an access indicator is illuminated in red. Failure to do so may result in
permanent data loss.
- Do not open the card slot cover of the card being accessed and do not remove the card.
- Do not disconnect the power source or turn off the camera.
• Be sure to save your recordings regularly (
A
147), especially after making important recordings. Canon shall
not be liable for any loss or corruption of data.
NOTES
NOTES
• You can use the review function (
A
109) to play back part or all of the last clip recorded without having to
switch to
mode.
• If you record using metadata settings, those settings will be recorded with the clip. For more details, refer to
Setting the RAW File Clip Name
(
A
61).
• If the camera switches to the other SD card while recording video due to the relay recording function (
A
the two parts (before/after the switch) will be recorded as separate clips.
• A single MP4 clip can be recorded continuously for up to 6 hours. At that point, a new clip will be created
automatically and recording will continue on a separate clip.
SD card access indicators
Tally lamp
CFast card access
indicator
Tally lamp