Canon EOS C200 EF Cinema Camera and 24-105mm Lens Kit - Manual (Page 26)

Preparing the Power Supply
26
Checking the Remaining Battery Charge
When the camera is turned on, you can check the approximate remaining battery usage time (in minutes) by
looking at any recording/playback screen or the [Battery/Hour Meter] status screen (
A 187). You can also
check the approximate charge level on the battery pack itself.
Press the CHECK button on the battery pack. An
indicator will light for approximately 3 seconds and show
the approximate remaining battery charge.
0-25%
26-50%
51-75%
76-100%
Using a Power Outlet
You can also power the camera directly from a power outlet using the supplied CA-A10 AC Adapter. While the
camera is powered using a power outlet, you can replace the battery pack even when the camera is turned on.
North America only: The power cord for the CA-A10 AC Adapter is different from that for the CA-CP200B
Compact Power Adapter. If you do not use the correct power cord, it will not connect to the AC adapter.
Attaching the Ferrite Core
Before using the supplied CA-A10 AC Adapter, attach the supplied ferrite core to the power cord. This can help
reduce the likelihood of RF interference.
1 Attach the ferrite core to the power cord about 4 cm (1.6 in.) from the plug that
goes into the AC adapter.
2 Pass the cable through the center of the core and wrap it around the core
twice and close the ferrite core.
• For use in North America, you only need to wrap the cable around the core
once.
CHECK button Battery charge
indicator
4 cm